BDS 440H 3" Lift Kit | 1986 - 1991 Jeep Comanche MJ

Important Kit Notes

• 1. The Jeep Comanche was produced with two different rear axles (Chrysler 8.25 or Dana 35). You will need to measure your rear u-bolts to ensure that you get the correct new u-bolts. Basically, just measure the diameter of the axle or the I.D. of your rear u-bolts. Some actually came with a Dana 44, if neither of the u-bolts listed fit your application, go to the u-bolt section and make your selection there.
• 2. The transfer case drop kit will not be necessary for 2WD applications.

This kit comes with two front Pro-Ride Coil Springs that are capable of withstanding full coil bind, a transfer case drop, extended sway bar links, and a front track bar relocation bracket to properly center your axle. The rear is lifted with a long thin add-a-leaf to add height without comprising ride and help to level your MJ.

• Tire & Wheel Combinations
• 31" x 10.50" w/15 x 8 and 3-1/2" - 4" back spacing

*Trimming may be required*

• Est. Installation: 6 hours
• Difficulty Level (easy 1 - 5 complicated): 3