Important Kit Notes
- 1. If your vehicle is equipped with a CV style drive shaft mount at the front pinion, then it will need to be replaced with a Spicer style u-joint drive shaft in order to eliminate vibration. See www.4xshaft.com
- 2. If you desire not to drop the transfer case, a slip yoke eliminator and dual cardan style driveshaft will be required.
BDS Suspension 4-1/2" Lift Kit for the 1993 - 1998 Jeep Grand Cherokee ZJ.
This kit comes with front and rear Pro-Ride Coil Springs and matching NX² series shock absorbers. These coils are made from 5160 spring steel and pre-set to handle anything that you can throw at them. The kit also includes heavy duty adjustable upper control arms to adjust the front alignment and the rear pinion angle. Front & rear lower control arms are included with 1/4 wall tubing. A new adjustable front track bar is included to properly center the front axle.
The rear track bar is relocated with a relocation bracket. Front Kevlar lined, stainless steel brake lines are included as well as the ultimate in sway bar disconnect systems. New rear sway bar links are also included as well as front and rear bump stop extension.
- Tire & Wheel Combinations
- 31" x 10.50" w/16 x 8 and 4-1/2" back spacing
*Trimming may be required*
- Est. Installation: 10 hours
- Difficulty Level (easy 1 - 5 complicated): 3
Total Reviews (0)
Write the First Review!