Important Kit Notes
- 1. Ball joint alignment cam will be required for alignment, these are available in the options section or from your local alignment shop.
- 2. Extra cab models may not achieve stated height.
- 3. Models equipped with a 2-piece driveshaft will require the carrier bearing crossmember to be lowered.
- 4. Bronco II 1985-90 models with CV joint type drive shaft must be converted to an exposed joint shaft.
- 5. Vehicles equipped with factory STX package will not achieve stated height
This system includes two front Pro-Ride Coil Springs, pitman arm for steering correction, radius arm drop brackets, heavy duty axle pivot drop brackets, bump stop extensions, anti-sway bar drop brackets, and brake line relocation brackets.
The rear is lifted with a 2" block and add-a-leaf system.
- Tire & Wheel Combinations
- 31" x 10.50" w/15 or 16 x 8 and 3-1/2" back spacing
*Trimming may be required*
- Est. Installation: 8 hours
- Difficulty Level (easy 1 - 5 complicated): 3
Total Reviews (0)
Write the First Review!