Important Kit Notes
- 1. 18" or larger diameter wheels required. Stock 17" & 18" wheels cannot be reinstalled. Stock 20" wheels can be used with up to a 305/60-20 tires.
- 2. E-brake bracket required for factory powersteps (123018)
- 3. For a level to tail low appearance use #023415 with Kit#599H. Block kits replace factory 1-1/4" block.
- 4. Early 2009 models may require brake assembly modification.
- 5. Vehicles equipped with 2 piece rear driveshaft may require carrier bearing drop kit #122405
This system includes CNC machined steering knuckles to return your vehicle's steering to factory geometry. One piece front & rear High Clearance crossmembers increase rigidity for long term performance as well as dramatically increase ground clearance and curb appeal.. This system uses upper front strut spacers to ease installation.
The rear is lifted with a new 4" offset rear block to replace the factory 2" and center the rear axle and give your 35's plenty of room.
Check out the similar 6" lift install article published in Four Wheeler magazine.
- Tire & Wheel Combinations
- 35" x 12.50" w/18 x 9 and 5" back spacing
- 35" x 12.50" w/18 x 9 and 4.5" back spacing
- 35" x 12.50" w/20 x 9 and 5-5.5" back spacing
*Trimming may be required*
- Est. Installation: 8-10 hours
- Difficulty Level (easy 1 - 5 complicated): 4
Total Reviews (0)
Write the First Review!