BDS Suspension expands its listings for the late model RAM HDs with new 6" radius arm systems for the rear air-ride equipped RAM 2500. Based on the popular BDS radius arm kits for the standard RAM HDs, these kit variants retain full functionality of the factory rear air-ride and on-road comfort while improving offroad capability
Up front these systems use a pair of progressive rate 6" coil springs to provide the extra height and smooth controlled performance in the harshest of terrains. A forged drop pitman arm is supplied to correct steering angles along with a HD bar drop bracket to re-center the front axle. A pair of sway bar drop brackets reposition the OE sway bar along with extended polyurethane bump stops to correctly limit up travel and brake line brackets to allow full droop. To correct the front suspension geometry at the new height a pair of heavy duty replacement radius arms are supplied to bolt in place of the factory arms. These new radius arms are massive upgrade to the factory stamped units, using tubular construction and a lower cam adjustment to dial in front end caster. Also supplied are your choice of BDS NX2 gas shocks or FOX 2.0 performance series IFP gas shocks for improved ride and performance.
At 6" of lift it is critical to correct the front driveline angle to maintain use of the 4WD. To do this BDS Suspension provides a heavy duty replacement transmission crossmember as well as a transfer case indexing ring to reposition the front driveline output to allow use of the factory drivelines. In the rear, heavy duty air bag spacer brackets are used to level the stance along with a rear track bar bracket to correct axle positioning, extended length sway bar links, and bump stop extensions. BDS supplies new air ride leveling sensor brackets to position the ride height sensors at the stock angle. This allows the rear suspension to be perform just like it does at factory ride height and maintain full air bag range of motion. The rear suspension is rounded out with your choice of NX2 series or FOX 2.0 shocks.
Get the look and the ride you are after with these new 6" radius arm systems from BDS Suspension.
- Tire & Wheel Combinations
- 37x13.50 w/20x9 and 5.625" back spacing
- 37x13.50 w/20x9 and 4.5" back spacing
- 37x12.50 w/17x9 and 4.5" back spacing
*Trimming may be required*
- Est. Installation: 8-10 hours
Important Kit Notes
- 1. Will not fit rear coil-spring equipped models
- 2. Fits diesel models only
- 3. Will not work with Manual shift transfer cases
Total Reviews (0)
Write the First Review!