Important Kit Notes
- 1. Will not fit Cab and Chassis models
- 2. Some trucks are equipped with rear dual overload springs. Order 4068 to retain top overload leafs.
- 3. Not for use with factory rear airbag suspensions
This kit is perfect for those looking for all the performance of a full-out lift system but with the height of a leveling kit. This new system is built around massive tubular replacement radius arms. These arms are built to handle far more than the factory parts they are replacing. The design incorporates a factory style rubber bushing mount at the frame to keep the NVH levels in check. The 3-1/4" diameter bushings are huge and have a long, maintenance-free service life. The new radius arms mount right into the factory locations so installation is simple and clean. Factory alignment adjustability is maintained using the OE eccentric adjusters. The arm geometry is set to keep the axle angle in the factory specs while compensating for the 3" of lift. A copper-anodized aluminum BDS name plate is mounted each arm.
In addition to the heavy-duty, high-performance radius arms, this new system features dual-rate front coil springs that improve the ride and handling of these 1 ton trucks both on and off road. Our popular heavy-duty turnbuckle style adjustable track bar is included to center the axle. BDS greaseable front sway bar links reset the sway bar to the optimum angle and round out the main front components. Add in the front brake line relocation brackets and a choice of NX² series or FOX 2.0 Performance Series shocks and this system is set to handle any terrain.
The rear system is a simple 2" block and u-bolt setup to level out the back with the newly lifted front.
- Tire & Wheel Combinations
- 35" x 12.50 w/17" x 9" and 5" back spacing
- 35" x 12.50" w/18" x 9" and 4.5 back spacing
- 35" x 12.50" w/20" x 9" and 4.5 back spacing
*Trimming may be required*
- Est. Installation: 5 hours
- Difficulty Level (easy 1 - 5 complicated): 3
Total Reviews (0)
Write the First Review!